Go to TOP

This product is out of stock, and not coming back.
It may have been replaced by a newer version, see replacement/alternatives listed below.

Automatic Irrigation Water Pump Diy Module Set For Garden Watering Gardening Tool Black

Product code: PHO_0TI5NTKE
OUT OF STOCK
.
Automatic Irrigation Water  Pump  Diy  Module Set For Garden Watering Gardening Tool Black
Automatic Irrigation Water Pump Diy Module Set For Garden Watering Gardening Tool Black
$10.41 
.

--Can be welded freely: you can adjust it according to your own needs

--Premium material: wear-resistant,sturdy and solid, and can provide long-term service

--Light in weight: Easy to carry and store,convenient for daily use and replacement

--Easy to install: simple and practical to install,no special tools are needed

--Fucntion: can be used to replace the automatic watering module

.

Description:
Name: Irrigation Module Set
Usage:
1. Test the relay module: connect the VCC relay module to 5V, GND to ground, to GND, the relay will jump, and the relay will recover when it is suspended. So you can hear the "click" relay sound repeatedly;
2. Test the soil moisture sensor module: connect the fork probe and the transmitter module with two DuPont wires, connect the VCC transmitter module to 5V, and GND to ground. Just after the power is turned on, the red light of the power light is always on, and the green light (blue) flashes once. ; The fork probe is directly inserted into the water, and the green (blue) light is on.
3. Connect the red wire of the pump to 5V, the black wire to ground, and the pump works, pay attention to the test for 1 second, and do not work for a long time in the air;
notes:
1. The baby can be welded freely, but it needs to be stripped, twisted and protected with black tape;
2. The pump cannot run in the air for a long time
3. The system is switched on and turned on, and the water pump is always working, which is correct. Because the probe cannot detect moisture in the air, the water pump has been working and there is no problem if it is correctly installed in the pot.
Please note that water should not be poured directly into the probe. Many people don't know that the moisture in the water will quickly rust and destroy.

Packing list:
1*relay module
1*Soil moisture probe + comparison module
1*small water pump
1*battery box 
1xUSB power cable
10*20CM Dupont Line (FF)
50CM*silicone water pipe

Note:
1. The baby can be welded freely, but it needs to be stripped, twisted and protected with black tape;
2. The pump cannot run in the air for a long time
3. It is correct that the water pump works all the time when the system is connected and started up, because in the air, the probe can not detect moisture, so the water pump works all the time, and there is no problem to correctly install it in the pot
4. Without power supply, you can use the power bank (5V DC) as the power supply, or use four No. 5 battery boxes to charge four batteries
5. Do not pour water directly into the probe

.

Customer Reviews(0)

5 out of 5
5 star rating 5 star rating 5 star rating 5 star rating 5 star rating
Automatic Irrigation Water Pump Diy Module Set For Garden Watering Gardening Tool Black
Deliverystarrs 5starrs 5starrs 5starrs 5starrs 5
Value for Moneystarrs 5starrs 5starrs 5starrs 5starrs 5
Packagingstarrs 5starrs 5starrs 5starrs 5starrs 5
Ease of Setup/Usestarrs 5starrs 5starrs 5starrs 5starrs 5
Function/Performancestarrs 5starrs 5starrs 5starrs 5starrs 5
Write Review
Date Launched: Jul 07 2021
Previous     Next
All categories 